INSTALLATION GUIDE FOR
LVP58 LED SERIES
RETAIN THESE INSTRUCTION FOR FUTURE USE
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
Page
3
of
3
INSTALLATION PROCEDURE
1.
Remove Luminaire from carton and inspect for damage.
2.
Remove Lens (see Figure 1) and/or Shroud (see Figure 2) by loosening (2) 8-32 screws. Set aside for
later use.
3.
Remove LED Board Assembly by loosening (4) 8-32 screws (see Figure 3).
4.
Disconnect Driver wires to LED Board Assembly. Set wire nuts aside for later use.
5.
Apply rectangular gasket to back of fixture.
6.
Mount fixture to surface using (2) ¼” hardware (see figure 4, hardware not included).
7.
Connect all supply wires in accordance with national and local electrical codes.
8.
Reconnect Driver wires to LED Board Assembly using supplied wire nuts from Step 4.
9.
Re-install LED Board Assembly using 8-32 hex screw. Do not over tighten.
10.
Re-install Lens and/or Shroud.
11.
Energize and test.
Lens Screws
Figure 1 - LVP58
Figure 2 - LVP58 LPL
Figure 3
–
LVP58 Reflector
Figure 4
–
LVP58 Backbox
LED Board
Assembly Screws
Mounting Holes
LPL Lens Screws
