INSTALLATION GUIDE FOR
ARV17/YRV17 LED
RETAIN THESE INSTRUCTION FOR FUTURE USE
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
Page
3
of
3
INSTALLATION PROCEDURE
1. Remove Luminaire from carton and check for damage
2. Remove tamper resistant screw at 6 o’clock position and turn ring/eyelid counter clockwise to release.
3. Remove Lens by loosening (4) 8-32 screws.
4. Set aside screws, lens, and ring/eyelid for later use.
5. Dis-connect Driver wires to LED Board Assembly. Set wire nuts aside for later use.
6. Remove LED Board Assembly by loosening (2) 8-32 hex nuts located near the raised center section of
reflector.
7. Apply round gasket to back plate
8. Locate Up arrow on plate and mount plate accordingly
9. Mount fixture to surface using (4) ¼ bolts (not included). While the fixture may be mounted directly to
junction box using keyhole slots provided, we recommend using the ¼ bolts for maximum vandal resistance.
10. Connect all supply wires in accordance with national and local electrical codes.
11. Re-install LED Board Assembly using (2) 8-32 nuts. Do not over tighten.
12. Connect Driver wires to LED Board Assembly using supplied wire nuts from Step 5. Connect black to blue
and red to red.
13. Install lens on fixture.
14. Align outer ring/eyelid so that the screw access hole is in the five o’clock position and engages with lens.
15. Turn ring /eyelid in the clockwise direction to engage with lens.
16. Re-install tamper resistant screw at six o’clock position.
17. Energize and test.
Set Screw
WARNING - The main (white LED) circuit and the auxiliary circuit (Nightlight) are to be wired to separate
circuits that can’t be powered on simultaneously.
