3. Align fixture over mounting bracket and push wires through center hole. Fixture should align from the
top of the bracket and will rest on the angled surface. Tighten two mounting screws to secure fixture
to bracket. (fig3).
4. Apply a bead of silicone caulk between the wall and top of fixture as required.
5. Loosen (3) screws in lens frame and swing door frame downward. (fig4)
6. Remove reflector by loosening ¼ hex screws.
7. Connect supply wires in accordance with code.
8. Re-install reflector
9. Install Lamp(s)
10. Tighten (3) Tamper Resistant screws to secure door frame.
11. Energize and test.
RETAIN THESE INSTRUCTION FOR FUTURE USE
Figure 3
Figure 4
Page
4
of
4
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
www.luminaireled.net
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
