16
After Sales Support
Telephone: 1300 366 144
Internet: [email protected]
Steam jet
The increased steam generation caused by the steam jet is primarily suited for
linen and wool as well as for dealing with severely crumpled items. Hold the steam
iron at a suitable distance from the item being ironed. This will avoid damaging the
fabric. The vertical steam jet delivers an additional measure of steam, for example
to smooth fabrics in a hanging position such as hanging drapes or other hanging
or stretched items of clothing without any contact with the ironing base.
Requirements: Water tank must be full.
1. Set the steam regulator (9) to position
or higher
2. Set the desired temperature according to the type of fabric to be ironed
(Temperature levels 5 to 9).
3. Press the steam jet button (2). The steam will shoot out from the holes in the
ironing base (10) into the fabric being ironed and remove the creases.
4. For severely creased items repeat the process as necessary. Do not press the
steam jet button (2) more than three times in a row.
5. Only use the steam jet function until the water tank is empty and no more
steam is being produced.
6. Turn the appliance off and unplug it from the mains. Refill the water. Careful, the appliance remains very
hot even after being switched off.
It may be necessary to press the steam jet button repeatedly in order to activate this function. After the
desired temperature level is attained, do not press the steam jet button more than three times in a row.
This will allow you to achieve optimal steam jet results. We recommend that you only use the steam jet
at temperature levels 5-9.
Anti-limescale system
In order to extend the life of your steam iron, an anti-limescale cartridge has been built in. It reduces the
formation and depositing of limescale in the steam nozzles and is cleaned using the self-cleaning function.
However, the anti-limescale cartridge does not completely prevent the natural limescale formation process.
Self-cleaning
The self-cleaning function removes accumulations of limescale and minerals in the steam chamber. After ap-
prox. 5 hours of steam operation or, at the latest, when the "Self-cleaning" symbol (B) appears on the display,
the ironing base (10) and/or the steam chamber must be cleaned using the self-cleaning function.
Danger of burns!
Avoid contact with steam and/or hot water.
Requirements:
– Water tank must be full.
– Temperature is set to temperature level "9".
1. Hold the iron horizontally over a sink.
2. Turn the steam regulator (9) to position
and hold this position. Steam and boiling water will escape
through the holes in the base. This will rinse out the limescale deposits and accumulations which have
