12
After Sales Support
Telephone: 1300 366 144
Internet: [email protected]
Starting up the appliance
Do not vacuum up: Toner, plaster, cement, stone dust, drilling dust, explosive or poisonous items, glow-
ing embers, burning cigarettes or matches, sharp-edged items like glass splinters, liquids!
Do not use the vacuum cleaner unless all filters and the dust container are properly in place.
Never cover the ventilation slots which can lead to the appliance overheating. Keep it at an adequate
distance from walls or other objects.
A holder for the upholstery nozzle and the crevice nozzle are included with the vacuum cleaner; you can
place the nozzles in the holder when they are not in use. The holder can be attached to the telescopic
tube.
• Place the appliance near a socket (with a rating plate showing mains voltage) and make sure that there is free
access to the socket.
• Ensure that the appliance in the holder stands on a level, dry and non-slip surface.
Using the appliance
• First take the nozzle you want to use and attach it as described above to the handle of the suction hose (M)
or the telescopic tube (P).
• Pull out the mains lead to the desired length (no further than the yellow mark).
• Connect the appliance to an approved socket, installed according to the regulations.
• Use the ON/OFF switch (G) to switch the appliance on with your foot. The motor will start
up and the appliance will begin vacuuming.
• Push and pull the respective nozzle carefully over the surface you want to clean, into cor-
ners as well if necessary.
• Adjust the suction power with the aid of the supplementary air valve (N), as shown in image
06.
The appliance must be switched off and disconnected from the mains by unplugging it from the mains
socket before it is used and before any accessories are removed or attached. Allow the appliance to
cool down to room temperature before cleaning it or putting it away.
• Switch the appliance off by pressing the On/Off switch (G).
• Remove the plug from the socket. When doing so, always take hold of the plug, never
the cord.
• To wind up the cord, press the button for cord storage (H). Caution, the powerful rewin-
ding action can cause the cord to “whip” uncontrollably. If necessary, hold the cord firmly.
• If you have used the floor nozzle (Q) with the telescopic tube (P), you can slide its retai-
ning lug into the recessed holder (I), as shown in image 07.
CAUTION: If you want to use the recessed holder (I), bear in mind that the telescopic tube (P) must always be
completely retracted for this. Hold the telescopic tube (P) with the attached floor nozzle (Q) perfectly vertical
while you insert the retaining lug in thethe recessed holder (I). Slide the retaining lug on the floor nozzle (Q) into
the recessed holder (I) as far as it will go.
Instructions
Image 06
Image 07
