02001055-01 Rev 1
Operation Manual:
CCPF-1500/2000-XX
Page 6 of 14
CCPF-1500/2000-XX INTERFACE
(continued)
PIN #
TITLE/DESCRIPTION
9
+15V
(Output) Maximum output current is 100mA. This pin is internally
tied to pins 11.
10
N/C.
Do not use
11
+15V
(Output) Maximum output current is 100mA. This pin is internally
tied to pins 9.
12
N/C.
Do not use
13
END OF CHARGE STATUS INDICATOR-
(Output) Open collector
output rated 30V, 100mA. Collector is tied internally to 4.02kohm pull-up
resistor. When the load capacitor reaches the programmed voltage, pin 13
is pulled low. Pin 13 will oscillate from high to low as the power supply
replaces charge that is bled through the feedback network.
Latched Low EOC signal is optionally available. The EOC signal will
latch Low when the load cap is fully charged and stays Low until the cap
is emptied by the PFN and the Inhibit signal will reset the EOC signal.
The Inhibit must be active for every charge/discharge cycle.
14
GND
15
N/C.
Do not use.
