Lumikit Sistemas para Iluminação
Lumikit Sistemas para Iluminação
Lumikit Sistemas para Iluminação
Lumikit Sistemas para Iluminação | www.lumikit.com.br
13
13
13
13
that speed is not enough for the customer we recommend to change the configuration to 100Mbps, in this case
the customer should make sure that the communication will work among all equipment.
To change between the settings keep the “ART-NET/CHANGE UNIV” button pressed while the interface is
connected, in this moment check the IP and UNIV LEDs:
•
In case the IP and UNIV LEDs blink 5 times, the interface will work in 100Mpbs or 10Mpbs;
•
In case the interface connect normally without the IP and UNIV LEDs blink, the interface will force
10Mbps speed in network communication.
4.
4.
4.
4.
Interface reset
Interface reset
Interface reset
Interface reset
To restore the default settings, it can be done the interface resetting, to do this press and hold the
“RESET/CHANGE IP” button for at least 15 seconds when turning the interface on:
When in reset mode, it is possible to easily choose between the following IP addresses, by pressing the
“RESET/CHANGE IP” button:
•
IP address: 192.168.0.30 - Netmask: 255.255.255.0; (This IP is compatible with all software produced by
Lumikit);
•
IP address: 2.0.0.30 - Netmask: 255.0.0.0; (This IP is compatible with the majority of the software
produced by third parties);
And the following Art-Net universes in the DMX outputs, by pressing the ”ART-NET/CHANGE UNIV.” button:
•
DMX output 0=Art-Net Universe 0; Output1=Art-Net Univ. 1; Output 2=Art-Net Univ.2; Output 3=Art-Net
Univ.4;
•
DMX output 0=Art-Net Universe 0; Output1=Art-Net Univ. 0; Output 2=Art-Net Univ.0; Output 3=Art-Net
Univ.0; (Using this setting, DMX outputs will be in the first DMX universe, this way it will work as a DMX
splitter or buffer);
After finished the desired configuration press the “PLAYBACK/SAVE CONFIG.” button.
To choose other settings see chapter 3.
5.
5.
5.
5.
Interface connection
Interface connection
Interface connection
Interface connection
The Lumikit PRO X4 and Lumikit PRO X4 RACK interface connection is simple: