background image

www.lumi-o.com

OASIS #5445 

STAINLESS STEEL HANDRAILS INSTALLATION WITH BRACES:

Step 1 

fig.1 

1-       Slide the braces in the top of the handrails . Lay the step on the side and fix both handrails on the step with the 3” bolt for the upper 
          holes (4), the 3 ½” for the lower holes(4) ,the nuts (8) and the washers(16).   (fig.1)
2-      Fill the ballast unit with sand, seal with the plastic cap and put the ballast unit at the appropriate place on the step.   (annex a)
3-      Move the step into the water and allow the air to escape.  Place the step by the pool wall leaving at least 1” between the step and the wall. 
          Ensure that the step touches the ground solidly.  Lower the braces until its rests on the sidewalk.  (annex b)
4-      Affix the braces on the sidewalk with concrete screws (not included ).   (annex c)

PVC HANDRAILS INSTALLATION :  

1-      Lay the step on the side and fix the PVC tubes on the step with the 3” bolt 
          for the upper holes (4), the 3 ½” for the lower holes(4), the nuts (8) and the washers(16).  (fig.1) Slide one brace on each of the rear 
          PVC posts. (Upper step) 
2-      Affix the handrails on the support tubes with the ¾” screws(4).  (fig.2)
3-      Fill the ballast unit with sand, seal with the plastic cap and put the ballast unit at the appropriate place on the step.   (annex a)
4-      Move the step into the water and allow the air to escape.  Place the step by the pool wall leaving at least 1” between the step and the wall. 
          Ensure that the step touches the ground solidly.  Lower the braces until its rests on the sidewalk.  (annex b)
5-      Fix the braces on the sidewalk with concrete screws (not included ).   (annex c)

Step 

p 2 

Handrail

PVC tube 

fig.2 

Step 1 

fig.1 

Brace 

PVC  

tube 

PVC  

tube 

3" Bolt (top)
3½" Bolt (bottom)

4x 

4x 

10x 

10x 

18x 

¾ Screw
3” Bolt
3½” Bolt

Additional Material 

PVC handrails 

- 4 x 39’’ PVC tube

- 4 x 3/4” screw

Stainless steel handrails 

- Sand 
  Note:   you may need  
  approximately 100 lbs of sand 

Not included: 

Helpful hint: 
To ease the installation of the rails and  
bolts, use a screwdriver to line up holes. 

- Concrete screws 

2x Brace 

- 2 x  handrail

- 2 x  plastic cap

- 2 x 3" bolt

- 2x  Flange 

- 2 x nut 

Handrails box content: 

Please choose one of the following installation according to your handrails and pool type.

Installation

Read carefully the cautions and every steps before assembly and using your step.

Caution : File off all stripped or sharp edges before assembly to avoid injuries and pool damage.

Rev.  2011-01-06

p.1

Отзывы: