Lumi-O spa-O, Руководство пользователя

Страница: 12 / 23

CONTROLS REFERENCE GUIDE
TEMPERATURE ADJUSTMENT
Temperature control can only be set between 26°C and 40°C (80°F - 104°F).
The last measured temperature is constantly displayed on the LCD.
Note: The last measured spa temperature displayed is current only when the pump has been running for at least 2 minutes.
On control panel, display the temperature setting by pressing Warm or Cool button once. To change the temperature setting,
press the Warm or Cool button again before the display stops flashing, each press of the Warm or Cool button will adjust
the temperature setting by 1°F.
After three seconds, the display will stop flashing and display the current spa temperature.
JETS
Firmly press the Jets button once to activate the low speed of the pump and twice for high speed. Firmly press the Jets
button again to turn off the pump. If the pump is left running at low speed, it will automatically shut off after 4 hours and, at
high speed, it will automatically shut off after 15 minutes. The low speed of the pump may run automatically at times to detect
the spa temperature and then to filter and/or heat to the preset temperature if needed, depending upon mode. When the low
speed turns on automatically, it cannot be deactivated from the panel; however, the pump can be put into high speed.
LED MULTI COLOR LIGHT
Turning the light switch quickly on and off will cause the spa’s lighting mode to change.
MODES
Your spa-Ô as been pre-programmed to “continuous” standard mode by the manufacturer. If you wish to have access to the other
modes (Ec-economical & Sl-sleep) you will need to set the #7 dipswitch to the “off” position. You will find the dipswitches in the
spa pack.
Standard Mode (St) is programmed to maintain the desired temperature. Note the displayed spa temperature is current
only when the pump has been running for at least 2 minutes. “St“ will be displayed momentarily when you switch into
Standard Mode.
Economy Mode
(Ec) heats the spa to the preset temperature only during filter cycles. “Ec“ will display constantly when
temperature is not current, otherwise it will alternate with temperature display.
Sleep Mode
(SL) heats the spa to within 6.6º C (20ºF) of the preset temperature only during filter cycles. “Sl“ will display
constantly when temperature is not current, otherwise it will alternate with temperature display.
To change mode, press the Warm or Cool button, then the Light button. Repeat until you reach the desired mode. Once the
mode is shown on the screen, wait a few seconds before touching the arrows to ensure the spa stays on the mode you
have chosen.
12