1
2
3
1b.Hang the bracket on the screw.
3.Screw the two knobs.
INSTALLATION
Attach C to A and slide B
into A, then tighten screws.
1a.Attach A to wall by 4 screws.
A
B
C
Fasten the screws after vertical
and horizontal rotation.
2.Wire the cable and cover the rubber.
•
power (wattage).
•An overdriven amplifier clips the waveforms and sends
distortion to the speakers.
•Clipping is usually audible; it may vary from a harsh sound to
a fuzzy or unclear sound.
•If you hear this condition at loud volume levels, turn down the
volume until the distortion is no longer present.
•Damage caused by operating the speakers at distorted volume
levels is not covered by the warranty.
Most speaker damage is caused by amplifiers with too little
Underpowering VS. Overpowering
NOTE:
The total number of speakers multiplied by the tap value
cannot exceed the output power (in watts) of the 70V/100V
amplifier. The above example shows 5 total speakers. Using the
16W taps, you will need an amplifier with at least (5) x (16) = 80W.
A good rule of thumb is to select an amplifier with 20% greater
power; in this case, an amplifier that delivers about 100W.
70V/100V
C
5
SPEAKERS
CONNECTED
IN
PARALLEL
USING
16W
TAPS
Example of 70V/100V System Configuration (for OWM-6T)
Tighten the screws
until fixed
.
CONNECTIONS
speaker
PACKING LIST
USER
MAN
UA
L
user manual
SAFETY INSTRUCTIONS
When the speakers are installed on the walls, ensure the
wall structure is reliable and that the speakers are firmly
attached.
1
2
3
4
5
Install the speaker in a location that can structurally support
the weight of the speaker and its mounting hardware.
Otherwise it may result in the unit falling down and causing
personal injury.
Do not listen to sound at a very high level when you are
changing the input source (for example, to tune FM / CD)
Installation or removal of cables should make sure that
the power amp / amplifier device radio is turned off.
Do not use nails, adhesives or other unauthorized devices.
Long-term use and vibrations may cause it to fall easily.
Do not touch or bump the woofer and tweeter. If these are
damaged, the sound will be distorted.
Example of System Configuration (OWM-6/6A/6BT)
speaker wire
power cable
3.5mm jack to RCA
Active version options
AC100-240V
LINE IN LINE OUT
+
-
EXTENSION
LOUDSPEAKER
MIN IMPENDANCE
8 OHMS
-14db +14db
-14db +14db
-14db +14db
TREBLE
BASS
VOLUME
POWER
POWER
RIGHT
AC100-240V
LINE IN LINE OUT
+
-
EXTENSION
LOUDSPEAKER
MIN IMPENDANCE
8 OHMS
-14db +14db
-14db +14db
-14db +14db
TREBLE
BASS
VOLUME
POWER
POWER
RIGHT
