SINGLE FIXTURE
CONTINUOUS SYSTEM
F
Remove the lenses (F) of all the fixtures in the run
with the included lens tool. If direct/indirect or
indirect, also remove the top lenses.
G
Disconnect LED molex connector (G) by taking a
pointed object and pressing on the two tabs on the
top.
G
H
Remove all the end LED cartridges (H). If direct/
indirect or indirect, also remove the top cartridge .
Lens
Tool
W W W . L U M E N W E R X . C O M
www.lumenwerx.com (T) 514-225-4304 (F) 514-931-4862 © All rights are reserved to LumenWerx ULC.
FILE NAME:VIA2-WALL-MOUNT-INST
November 15, 2019
Page: 1 / 3
LumenWerx ULC. reserves the right to change or modify product specifications without notification
WALL MOUNT - INSTALLATION INSTRUCTIONS
VIA 2
NOTE
: Wire dimming conductors as Class 1
1
4
2
5
3
6
Make wire connection between fixture (B) and
wall power cable (C).
Number of wires may vary.
Insert fixture bracket (D) into wall bracket (A), and
secure in place with suplied screws (E).
A
B
A
C
A
E
D
SIDE VIEW
Locate wall bracket position using provided client
drawing. Install mounting brackets (A) to wall.
Align with structural stud (need double studs –
distance between screws is 1.250”) or use metal
anchors with min. length 1.250”. Flat head Philips
drive screw, nominal size #10, min. length 1.250”.
