3
• It is not recommended to use more than one repeater per universe. For more information, please contact LumenRadio
• The transmitter and repeater must always be linked first before any receivers are added to the repeater.
• Switch off all receivers that are in range until the transmitter and repeater have been successfully linked.
• On any repeater or receiver that is about to be linked to a transmitter, ensure that the RF Link indicator is off. This indicates
that the unit is not already linked to another transmitter. If necessary, follow the unlink procedure.
N L
E
Eart
h
Live
(100-240
VAC)
Neutr
al
DMX
+
Rese
rved
DM
X-
Ether
net (F
lex
mode
ls only
)
Reserv
ed
Groun
d
POWER AND SIGNAL CONNECTORS
Remove the outer and inner covers of the unit and then remove the lower cover plate to gain access to the connectors.
Power and data connections are made via the two (or three, if needed) cable glands in the underside of the main enclosure.
Flex models also support Power over Ethernet (PoE) as an
alternative to a mains power input (5W load).
WARNING
Ensure that the power supply is switched off before the
casing is opened.
A readily accessible UL Listed Circuit Breaker rated 20A
shall be incorporated in the building installation wiring.
STEP 1
Link the transmitter to
the repeater(s)
STEP 2
Link the repeater to the
receiver(s)
T
ransmitter
Repeater
Receiver
STEP 2 - TO LINK THE REPEATER AND RECEIVER(S)
1 Power on the receiver(s).
2 On the repeater, press and release its
button. The repeater will search (for a period of ten seconds) for any unlinked receiv-
ers. Its RF Link indicator will flash.
At the end of the search period, all located receivers will be linked to the repeater, which is in turn linked to the
transmitter. The RF Link indicators will be on and the current signal quality will be shown by the indicators on the left of the
display panel.
USING CRMX OUTDOOR FLEX AS A REPEATER
PLEASE NOTE THE FOLLOWING GENERAL POINTS:
TO UNLINK RECEIVER(S) FROM A REPEATER
•
Unlink one:
On the receiver, press and hold its
button for more than 3 seconds to unlink it from a repeater. The RF Link
indicator will extinguish.
•
Unlink all:
On the repeater, press and hold its
button for more than 3 seconds to unlink all of its receivers.
TO UNLINK REPEATER(S) FROM A TRANSMITTER
•
Unlink one:
On the repeater, press and hold its
button for more than 3 seconds to unlink all of its receivers. The RF Link in-
dicator will flash. Within 5 seconds of the RF Link indicator has stopped flashing, press and hold the
button for 3 seconds
to unlink the repeater from the transmitter.
•
Unlink all:
On the transmitter, press and hold its
button for more than 3 seconds to unlink all of its repeaters and recivers.
Note that unlinking a repeater from a transmitter will also unlink any receivers that are linked to the repeater.
STEP 1 - TO LINK THE TRANSMITTER TO THE REPEATER
Follow linking procedure on page 2.
NOTE
