Full product range & more information:
www.lumenalights.com
OLYMPIA TECHNOLOGY:
The Olympia is a highly efficient solar light with high capacity LiFePO4 Lithium batteries and a fast charging Monocrystalline solar
panel. This means that even on partially cloudy and rainy days, it will re-charge efficiently. The high battery capacity gives enough
power for up to 23 hours solid light (approx. 2-3 nights) even when there is little light during the day. The high lumen light
output is bright enough to illuminate driveways, entrances and paths, with a downward spread light projection, making them safe
to navigate at night.
INSTALLATION:
Recommended spacing is 3m apart for substantial, constant lighting. For best performance
mount in a sunny position
–
south facing is recommended.
Location
–
It is important that the installation location is carefully considered, avoiding shady areas.
Ensure there is no other lights which could interfere with the light, imitating daylight and forcing the light
off.
1.
Remove the backing plate / mount from the body by unscrewing the dome nuts at the front.
2.
Use the plate to mark the mounting holes on the mounting surface in the desired location (use a
spirit level to ensure the holes are straight)
–
See point A.
3.
Remove the mounting plate and drill out the 4 holes marked
–
use screws / wall plugs relevant to
the mounting surface and with a head / washer larger than 8mm. Maximum screw size is M7.
4.
Attach the mounting plate to the surface securely with the selected screws.
5.
Place the wall light back onto the mount, pushing the threaded bars
through the holes
–
See point B.
6.
On each side, replace the large flat washer, followed by the split / lock
washer and then the dome nuts
–
tighten securely
–
See point C.
7.
Use a spanner to fully tighten
–
leave a gap between the spanner and
back mount cover to ensure to fitting does not get scratched.
SETTINGS:
The Olympia has a pre-set time controlled setting which cannot be changed. At dusk, the light will illuminate at full brightness,
and then follow a gradual dimming sequence until it reaches 30% brightness after 5 hours. From then on it will remain at 30%
until dawn, or until the battery charge is exhausted. This sequence is to ensure the maximum charge is retained.
IMPORTANT
–
SOLAR WALL LIGHT MUST BE TURNED ON AT ALL TIMES AFTER INSTALLATION
If the wall light is left in the off position, you may be prompted to turn the fitting on by strobing.
Solar wall light will only charge when in the ON position.
Turning on the wall light
1)
Remove the waterproof rubber bung located just below the polycarbonate lens, in line with the Lumena Logo, to locate
the red on/off button.
2)
Using a small, flathead screwdriver (or similar), push the on button inwards until it clicks and allow to pop back out
(this will be partial). The pedestal is now in the ON position.
3)
Replace the waterproof, rubber bung.
4)
To turn off for storage, repeat the same procedure as above.
NOTE:
There will be a 2-5 second delay between turning the solar light on, and the wall light illuminating. In daylight, the light
will turn back off within a few seconds, in darkness it will remain on and follow the time-controlled cycle. If unsure, cover the
solar panel to check if the fitting turns on.
STORAGE:
When storing the bollard, be sure to turn the bollard to the off position by following the above steps (check by covering and
uncovering the solar panel). Once pressed, the on/off button will release fully forward. Maximum 6 months storage when fully
charged
–
recharge will be required periodically to prevent damage to battery over long periods of time.
126mm
7mm
44m
m
88m
m
Depth 1.5mm
A.
B.
C.
