Full product range & more information:
www.lumenalights.com
OLYMPIA TECHNOLOGY:
The Olympia is a highly efficient solar light with high capacity LiFePO4 Lithium batteries and a fast charging Monocrystalline solar
panel. This means that even on partially cloudy and rainy days, it will re-charge efficiently. The high battery capacity gives enough
power for up to 23 hrs solid light (approx. 2-3 nights) even when there is little light during the day. The high lumen light output
is bright enough to illuminate driveways and paths, making them safe to navigate at night, with a downward spread light
projection.
INSTALLATION:
Designed to be mounted on a low wall, wood, patio or set in concrete (J-Bolts sold
separately) via the internal surface mount.
Recommended spacing is 3m apart for substantial lighting. Closer spacing /
staggering will result in a more intense light.
Location
–
It is important that the installation location is carefully considered,
avoiding shady areas. Ensure there is no other lights which could interfere with the
light, imitating daylight and forcing the light off.
1.
To surface mount, remove the internal base from the bollard by unscrewing
the 3 x cross head screws at the bottom of the bollard tube, then lift off.
2.
Use the base to mark the mounting holes on the mounting surface.
3.
Remove the mounting plate and drill out the 3 holes marked at the relevant depth and diameter for the mounting
screws / wall plugs being used (varies based on mounting surface)
–
Anchor bolts
recommended.
4.
Secure the mounting base in place
–
large washers may be required.
5.
Replace the bollard body, lining up the 3 x holes at the base.
6.
Replace the 3 cross head screws removed in point one to secure in place.
For root mounting, use J-Bolts, set in concrete instead of anchor bolts (sold separately).
SETTINGS:
The Olympia has a pre-set time controlled setting which cannot be changed. At dusk, the bollard will illuminate at full brightness,
and then follow a gradual dimming sequence until it reaches 30% brightness after 5 hours. From then on it will remain at 30%
until dawn. This sequence is to ensure the maximum charge is retained.
IMPORTANT
–
SOLAR PEDESTAL LIGHT MUST BE TURNED ON AT ALL TIMES AFTER INSTALLATION
If the pedestal light is left in the off position, you may be prompted to turn the fitting on by strobing.
Solar pedestal will only charge when in the ON position.
Turning on the pedestal light
1)
Remove the waterproof rubber bung located just below the polycarbonate lens, in line with the Lumena Logo, to locate
the red on/off button.
2)
Using a small, flathead screwdriver (or similar), push the on button inwards until it clicks and allow to pop back out
(this will be partial). The pedestal is now in the ON position.
3)
Replace the waterproof, rubber bung.
4)
To turn off for storage, repeat the same procedure as above.
NOTE:
There will be a 2-5 second delay between turning the solar light on, and the pedestal illuminating. In daylight, the light
will turn back off within a few seconds, in darkness it will remain on and follow the time-controlled cycle.
STORAGE:
When storing the pedestal light, be sure to turn the bollard to the off position by following the above steps (check by covering
and uncovering the solar panel). Once pressed, the on/off button will release fully forward. Maximum 6 months storage when
fully charged
–
recharge will be required periodically to prevent damage to battery over long periods of time.
Depth 8mm
60mm
13mm
120mm
68mm
