ENG
4
Safety instructions
- The device is only usable with the light units produced by Lumen Aquatech DOO.
Connecting different types of lighting devices is forbidden.
- The controller can only be safely removed or connected to the lamp with disconnected network cable.
- Do not extend or connect the cables in a non-standard way.
- The light source emits heat during operation, thus it should not be used near flammable materials.
- The device must be protected from strong impurities and rough external influences.
Furthermore, knocking, drilling or modifying it in any way is strictly forbidden!
It’s also forbidden to use or to install it with any electronic product with a broken or defective connector!
- Devices operating on 12 or 24 volts of extra low voltage must NOT be connected to the 230V main power source,
because of the high risks of electric shock, accident and fire! The device can only be connected to the power supply
specified by Lumen Aquatech DOO! Failure caused by supplying the device with incorrect voltage is not a warranty defect!
- Covering the device is flammable, thus strictly forbidden! When installing such products, make sure that the unit is well ventilated.
- In humid environments, only use suitable products with IP44 or higher intrusion protection.
Products with protection below IP44 can cause electric shock in humid, wet environments!
- Never touch wet / humid electronic devices under voltage!
- To protect children, store electronic devices out of their reach!
- Never look directly into the light source!
- Electrostatic discharges (ESD) may damage internal electronic components!
- Ignoring the instructions given in this guide may result in fire, electric shock, burns, personal injury,
and other property and non-property related damage.
Our company cannot be held responsible for the lack of compliance with this guide.
About the application
On the Dashboard, you can quickly to go the preset to set the program. And switch ON/OFF for the lighting intensity,
effects, expands easily, which to help you rule all the status of your devices as system.
Devices list
Quick set
Set 12V expand
Modes
ON/OFF
Power bar
Current device
Set acclimation
Channels intensity
Set 24V expand
Effects ON/OFF
