Lumberjack YTL-590-111, Инструкция по эксплуатации

Страница: 9 / 25

‐ 9 ‐
STEP 5: Attach the Cylinder Cover and the Hydraulic Hose
5.1 Pull the cylinder assembly back until the two mounting ears on the cylinder snap into the groove, then
re-install the cylinder cover (#3) into its’ original position and tighten it with the hex bolt M8x16 (#41),
the lock washer Ø8 (#48) and the flat washer Ø8 (#43).
5.2 Remove the plug from the hydraulic hose, then install the hydraulic hose (#32) onto the beam. To
properly attach the hose, screw in a few teeth by hand into the correct location then tighten it with a
wrench.
A small amount of oil may leak from the hoses when the plugs are removed. To prevent oil
from dripping on the ground, use a small pail to catch any oil and put down cardboard.
STEP 6: Attach the Engine to the Mounting Plate
6.1 Attach the engine (#20) to the mounting plate using the hex bolt M8x40 (#49), the flat washer Ø8
(#43), the lock washer Ø8 (#48) and the lock nut M8 (#27).
6.2 Remove the plugs from the hydraulic hose and the gear pump connector. Attach the hydraulic hose
(#34) to the connector of the gear pump (#44). When attaching the hose hand screw in a few teeth
then tighten it with a wrench.
6.3 Remove the plug from the gear pump connector, then attach one side of the clear oil pipe (#31) to the
connector of the gear pump (#44). Remove the film bag from the opening of the oil filter mounting
plate, then attach the other side of the clear oil pipe to the opening of the oil filter mounting plate.
Secure the clear oil pipe with the clamp (#15).