Lumberjack SCMS210SB, Руководство по эксплуатации

Страница: 11 / 23

Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood‐treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Always use dust extraction or the Dust bag
provided (
11).
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter‐class
respirator.
Observe the relevant regulations in your
country for the materials to be worked.
The dust/chip extraction can be blocked by
dust, chips or workpiece fragments.
– Switch the machine off and pull the mains
plug from the socket outlet.
– Wait until the saw blade has come to a
complete stop.
– Determine the cause of the blockage and
correct it.
Integrated Dust Extraction.
– Insert the dust bag firmly onto the machine
During sawing, the dust bag must never come
in contact with moving tool components.
Always empty the dust bag in good time.
External Dust Extraction
For dust extraction, you can also connect the
extraction port to a vacuum hose (internal Ø
40 mm).
The dust extractor must be suitable for the
material being worked. When vacuuming dry
dust that is especially detrimental to health or
carcinogenic, use a special dust extractor.
Changing the Blade
– Make sure that the electrical plug is removed
from the power point.
– Push down on the operating handle (
3 ) and
pull the release knob (
4
) to disengage the saw
arm ( 3 ).
– Raise the saw arm (
3
) to its highest position.
– Loosen the cover plate screw about 2 turns
with a Phillips screwdriver. Do not remove this
screw from the tool.
– Pull the rotating blade guard (
8 ) down.
When the rotating blade guard (
8
) is positioned
over the upper fixed blade guard
(
6
it is possible to access the blade bolt.
– Lift and hold up the lower blade guard ( 8 ) to
expose the threaded blade bolt.
– Hold the rotating guard (
8 ) up and press the
spindle lock button (
22
). Rotate the blade until
the spindle locks.
– Use the 6 mm hex key provided to loosen and
remove the blade bolt. (Loosen in a clockwise
direction as the blade screw has a left hand
thread).
– Remove the flat washer, outer blade washer
and the blade.
–Wipe a drop of oil onto the inner blade washer
and the outer blade washer where they contact
the blade.
– Fit the new blade onto the spindle taking care
that the inner blade washer sits behind the
blade.
– Replace the outer blade washer.
– Depress the spindle lock button (
22
) and
replace the flat washer and blade bolt.
– Use the 6 mm hex key to tighten the blade bolt
securely (tighten in an anti‐clockwise direction).
– Lower the blade guard hold the rotating lower
blade guard (
8 ) and blade bolt cover
(
10
) in position and tighten the fixing screw to
secure the blade bolt cover in position.
SCMS210SB 09
ASSEMBLY