RHD1050
08
OPERATING INSTRUCTIONS
Operating
WARNING: Always make sure the power tool is
isolated from the power supply before fitting
any attachment
Handle
Always make sure the fixed handle is secure
before any job takes place as a loose handle
could invite injuries.
FIG1
Switching the chisel on/off
The chisel has an on/off switch built in to the
handle. Holding the chisel with both hands
simply squeeze the trigger and the motor will
start. To switch off release the trigger.
FIG2
WARNING: The electric hammer chisel continues
for a few seco nd
s
after the trigger has been
release, be careful when putting it down.
Fitting a chisel bit into the Hex housing
FIG3
Put the bit into the hex housing
Put the bit into the hex housing and clamp the bit
by turning the stop lever half a turn anti clockwise.
This will lock the bit in place.
FIG4
Do not use the chisel until you are satisfied the
bit is secured.
