d) Keep the spindle block button pressed in and
screw the locking nut, turning it in an anti-clockwise
direction. Do not use pliers.
e) Screw the threaded end of the flexidrive onto the
body of the too and tighten screwing in a clockwise
direction.
Operation
Changing the insert and accessories on the
flexidrive.
To change the insert or to install accessories on the
flexidrive, follow the same general procedure for
changing attachment on the main body except
instead of using the locking nut. Turn the spindle until
the hole in the shaft is in line with the hole on the
handle of the flexidrive and insert a 1/8” drill bit to
block the shaft.
Flex Light
a) The Flexi light uses lithium ion batteries (batteries
included)
b) Slides into slot at back of the tool
Start up
a) Never start up the tool with the accessory
touching the work piece.
b) Hold it firmly and press the ON/OFF switch.
c) The tool will run continuously until the switch is
turned to off position.
Speed Adjustment
a) Do not change the tools speed as it is actively
being used.
b) The speed switch is located at the rear of the tool.
Turn to increase or reduce speed
DRT170/120 08
