Lumberjack BTS210, Инструкция по безопасности и эксплуатации, Страница: 6 / 23

BTS210 04
GENERAL POWER TOOL SAFETY WARNINGS
7.12 If the saw blade should become jammed,
switch the machine off and hold the work
piece until the saw blade comes to a
complete stop. To prevent kick back, the work
piece may not be moved until after the
machine has come to a complete stop.
Correct the cause for the jamming of the saw
blade before restarting the machine.
7.13 Do not use dull, cracked, bent or
damaged saw blades.
Unsharpened or improperly set saw blades
produce narrow kerfs causing excessive
friction, blade binding and kickback.
7.14 Always use saw blade with correct size
and shape (diamond versus round) of arbour
hole.
Saw blades that do not match the mounting
hardware of the saw will run eccentrically,
causing loss of control.
7.15 Do not use high speed steel (HSS) saw
blade.
Such saw blades can easily break.
7.16 Do not touch the saw blade after
working before it has cooled.
The saw blade
becomes very hot while working.
7.17 Never operate the machine without the
insert plate. Replace a defective insert plate.
Without flawless insert plates, injuries are
possible from the saw blade.
7.18 Store the machine in a safe manner
when not being used. The storage location
must be dry and lockable.
This prevents the machine from storage
damage, and from being operated by
untrained persons.
7.19 Never leave the machine before it has
come to a complete stop.
Cutting tools that are
still running can cause injuries.
7.20 Never use the machine with a damaged
cable. Do not touch the damaged cable and pull
the main plug when the cable is damaged while
working.
Damaged cables increase the risk of an electric
shock.
8. Safety Warnings for Lasers
The mitre saw has a built‐in laser light. The laser
is CLASS 2. These lasers do not normally present
an optical hazard. However, DO NOT stare at the
beam, as this can cause flash blindness.
8.1 Do not remove or deface any product
labels.
Removing product labels increases the
risk of exposure to laser radiation.
8.2 The laser beam can be harmful to the eyes.
Always avoid direct expose to eyes. Do not
project the laser beam directly into the eyes or
at any object other than the work piece.
8.3 Do not look directly into the laser‐beam‐
output aperture during operation.
8.4 Turn the laser on only when making cuts.
The laser on the mitre saw is not a toy. Always
keep it out of the reach of children. The laser
light emitted from this device should never be
directed toward any person for any reason.