BM16 03
GENERAL POWER TOOL SAFETY WARNINGS
c) When Battery pack is not in use, keep it away
from other metal objects, like paper clips, coins,
keys, nails, screws or other small metal object
that can make a connection from one terminal
to another.
Shorting the battery terminals
together may cause burns or a fire.
d) User abusive conditions, liquid may be
ejected from the battery; Avoid contact. If
contact accidentally occurs, flush with copious
amounts of water. If liquid contacts eyes, seek
medical help immediately.
Liquid ejected from
the batter may cause irritation or burns.
7. Additional Safety and Working
Instructions
a) Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metals can be harmful to one’s health and
cause allergic reactions, leading to respiratory
infections and/or cancer.
Materials containing
asbestos may only be worked by specialists.
Observe the relevant regulations in your country
for the materials to be worked.
b) Prevent dust accumulation at the workplace.
Dusts can easily ignite.
8. Additional Safety Warning for hollow
chisel mortisers
a) DO NOT OPERATE THIS MACHINE
until it is
assembled
and
installed
according to the
instructions.
b) OBTAIN ADVICE FROM YOUR SUPERVISOR,
instructor, or another qualified person
if you are not
familiar with the operation of this machine.
c) FOLLOW ALL WIRING CODES
and recommended
electrical connections.
d) MAKE CERTAIN
the machine is fastened to a
supporting surface to prevent it from tipping over
during operation.
e) NEVER
turn the mortiser
“
ON
”
before clearing
the table of all objects (tools, scrap pieces, etc.).
f) ALWAYS
keep hands, fingers and hair away from the
rotating bit.
g) DO NOT
attempt to mortise material that does not
have a flat surface, unless a suitable support is used.
h) ALWAYS
position holddown directly over workpiece
to prevent workpiece from lifting during operation.
i) ALWAYS
support workpiece securely against fence to
prevent rotation.
j) BE SURE
drill bit is sharp, not damaged, and properly
secured in the chuck before operation.
k)
MAKE SURE
chuck key is removed before starting
machine.
l)
NEVER
turn on the power with the drill bit or chisel
contacting the workpiece.
m) NEVER
perform layout, assembly, or set-up work on
the table while the mortiser is operating.
n) ADJUST
the depth stop to avoid drilling into the
table.
o) ALWAYS
turn off the power before removing scrap
pieces from the table.
p) SHUT-OFF
the power, remove the drill bit and chisel,
and clean the table before leaving the machine.
q) FOR YOUR OWN SAFETY
–
Don’t wear gloves
when operating the machine.
r) SHOULD
any part of your tool be missing, damaged,
or fail in any way, or any electrical component fail to
perform properly, shut off switch and remove plug
from power supply outlet. Replace missing, damaged,
or failed parts before resuming operation.
