VANTAGE features a forward clicky switch and multi-level digital output control circuit with
memory functions.
Half-press the tail switch to power on VANTAGE momentary, full press to lock it for constant
on. Another full press to release the lock (power off). As Vantage designed with Thread-Lock
system, loose the tail switch by half turn will avoid the flashlight from power-on.
Digital output control
Half press to cycle the output from Low, Medium and High.
At each output level, with a full press to lock it.
You can change the output by power off and on (within 1 second). As the powered on over 1
second will remains the same output with your next start.
Tactical Lock – Select the desired level and remains the power on for 1 second, then 4
half-press within another 1 second to lock the selected level. Further power on will always
remains the same output until Unlock.
Unlock – 4 half-press within 1 second
Battery Installation
Unscrew the tail switch housing and insert new batteries with positive ends towards LED
assembly. Replace tail switch and hand tighten. Depress tailcap pushbutton switch to test.
Note: It would not light if battery is inserted in wrong direction.
VANTAGE with digital polarity protection design.
CAUTION:
VANTAGE tool-light are high-output lighting devices. Due to possible eye
injury, DO NOT look directly into the reflector when the light is switched on. S
afety is
your responsibility, too.
External surface temperature will rise during prolonged operation; this is a normal operating
phenomenon.
Battery Replacement
If there is significant decrease in brightness of light output you should replace the battery.
Unscrew the LED-engine and remove the old battery. Insert a new battery as mentioned in
Battery Installation Guide
WARNING:
Do not place loose batteries in a pocket, purse or other container
containing metal objects or store with hazardous or combustible materials. Store in cool, dry,
ventilated area. Follow applicable laws and regulations for disposal.
Maintenance
Clean and lubricate threads with a clean cloth and apply thin coat of silicon-based lubricant to
rubber O-rings. Note: Do not use petroleum-based lubrication on O-rings. After prolonged
exposure to moisture, the bezel and batteries should be removed, inspected, and dried if
necessary
.
