Version 160505-0833
5: Install the Camera
Thread the wires from your camera through the face plate, then attach your
camera to the face plate using the screws supplied with the camera.
Hang the looped wire attached to the face plate over the hook on the interior of
the junction mount. This holds the camera in place, leaving your hands free.
Connect the camera wiring to your surveillance network.
Once everything is connected, screw the bullet / face plate assembly onto the
housing.
You can now power up your camera and finish installation using the
instructions in its manual.
6: Weatherproofing
While the gasket provided helps block moisture, we recommend you run a
silicone bead between the base of the bullet and the face plate, as well as
between the junction mount and the mounting surface. If the wiring runs out
of the side of the housing, also seal the conduit connector.
Support
If you need help, email [email protected]. For information, instructional
videos, support documentation, or ideas, visit our website.
5-Year Limited Warranty
This Luma Surveillance™ product has a 5-Year Limited Warranty. This warranty
includes parts and labor repairs on all components found to be defective in material
or workmanship under normal conditions of use. This warranty shall not apply to
products that have been abused, modified or disassembled. Products to be repaired
under this warranty must be returned to a designated service center with an assigned
return authorization (RA) number. Contact technical support for an RA number.
Copyright ©2015 Luma Surveillance. All rights reserved.
4: Install the Housing
Using the self-adhesive template provided, drill pilot holes as needed, as well
as a cable hole through the mounting surface if desired.
Remove the self-adhesive template.
Secure the housing to the mounting surface.
Thread the wires from your surveillance
system through the housing.
