7Remove Tool Head
7A
The tool head is attached with three screws. The print surface can be damaged if the tool head is
allowed to fall onto the print surface. With one hand, support the tool head while following
removal steps below.
7B
Using the 2.5mm hex key,
unscrew
the three M5 screws securing the tool head to the X-axis
carriage. Remove the
rear
screw first, followed by the remaining top two screws.
7C
Remove the tool head from the printer by moving the tool head away from the printer.
Note: In previous versions of our tool heads, the Esteps (Extruder Steps Per Unit) were listed
along the back of the tool heads for the customer to update. For the new Aerostruder tool head
however, the Esteps are now set up within the firmware, and no manual updates are required.
Rear
screw
Top
screws