Lukas AMIN 30 BSH, Руководство по эксплуатации

Страница: 5 / 18

15 - AMIN 30 BSH - Stand: 21.11.2008
The lubricator must be adjusted so as to supply approx. 3 drips per minute at a
pressure of 0,63 MPa. Only oil types quoted in the table below may be used.
In the case of a prolonged period without use (e.g. overnight), the machine must be
disconnected from the compressed air system.
Suitable oil types Viscosity
Festo Spezialöl
Aral Vitam GF 22
Esso Nuto H 22
Mobil DTE 22
BP Energol HLP 22
Shell Tellus C 22 22 mm²/s(=cSt) bei 40°C
ISO-Klasse VG 22
nach ISO 3448
4. Usage
Only tools may be used which are suitable for the power tool and which have a shaft
diameter that is correct for the collet. The use of cutting discs as well as groove and
profile milling cutters is prohibited.
Only use tools with a permissible operating speed of at least the maximum speed of
the power tool.
When using mounted points, the largest recommended distance L
0
between the
collet and the rear side of the abrasive wheel is 10 mm (see illustration). When this
distance is greater, the permissible speed is reduced. The burr manufacturer's
recommendations must be adhered to. A minimum clamping length of 10 mm must
be observed, independent of the type of tool used.