Lufft CHM 8k, Руководство пользователя, Страница: 28 / 72

Operating Manual CHM 8k
R1.7 / 01-2020
Communication via RS485 & Ethernet 28
Parameter Short
cmd
RS485
Default
value Range / short description
Zenith ZET 0 0 - 90 degrees (x 100)
Web
(e.g. 10.25
RS485
and 1025
Web
)
0° is vertical
Table 4 List of configurable parameters,
* can be set in service mode,
Web
format for web interface, or only in web interface available
RS485
format for RS458, or only for RS485 available
Parameter Short
cmd
RS485
Default
value Description
APDBreakdown UBR Device-dependent (e.g. 172000 mV)
ApdTempGradient TCO Device-dependent (e.g. 1090 mV/K)
IPDhcp IPD IP address DHCP
LifeTime(h) LIT Number of hours that the laser is in operation
Parameters
RS485
Prints a list of all parameters that are available
in the RS485 mode
SerLOM LOM TUByyxxxx Serial number of the measuring unit (LOM)
SystemLifeTime(h) SLT Total number of all operating hours of the CHM
system
TBCalibration TBC Scaling factor compared to reference
VersionFirmware VFI Firmware version
(data processing and handling)
VersionFPGA VFP Firmware FPGA
VersionLinux VLI Operating system version
Table 5 List of read-only parameters, accessible via the RS485 interface;
RS485
only for RS485 available
Explanatory notes to Table 4
AFDMode: Switch on / off the extended file distribution system via LAN / WAN / DSL, see
http://www.dwd.de/AFD/ for more information or section 8.8 AFD mode.
Altitude(m): Specification of the height of the location above sea level in meters. In NetCDF files, the
parameter CHO (Cloud Base Offset) is used. It logically combines the variables Altitude and UseAltitude.
Azimuth: Specification of the horizontal angle in degrees.
Baud: Change baud rate (see 8.2.3 Changing the baud rate).
BaudAfterError: Default baud rate after communication error (see 8.2.3 Changing the baud rate).
BlowerMode: Used to test the window fans and switch to different operating modes.
Mode 2: “rest at
night” works only correctly if the parameter TimeZoneOffsetHours is set correctly, too. 0 = hourly check
and weather-dependent, 1 = no hourly check from 22:00 to 06:00, 2 = off from 22:00 to 06:00, 3 = always
on, 4 = always off.
DataTime: Sets the date and time (see 8.3.6 Additional data telegrams).