MVP3 Main Board
15
2-3-5 JP7 CMOS Status----clearing content of CMOS
JP7
is a 3-pin connector. Clear CMOS if system password is forgotten. Below is
details to show how to clear CMOS.
JP4
CMOS Status
1-2
Normal
2-3
Clear CMOS
Procedure to clear CMOS:
Step 1: Shut down the system and disconnect the power supply from AC power.
Step 2: Pull out the AT cable from AT connector.
Step 3: Short the CMOS jumper by putting jumper cap on Pin 2-3 for a few seconds.
Step 4: Return to pin 1-2 for normal setup.
Step 5: Link power cable to the connector & connect AC power to power supply.
Step 6: Turn on system power.
if you’d like to set password, press “Del” Key during system bootup to enter
CMOS setup and establish a new password.
Pin1
JP7: CMOS status
