ENRICH BTE USER MANUAL
1
2
3
Microphone
Battery Door
Rocker Switch
TIP: Keep unit dry - remove when bathing
BATTERY INFORMATION
INSERTION:
Remove adhesive sticker on
#13 battery. Open battery door and place
battery with + side upward. Closing the
door will activate the unit in Program 1.
REMOVAL:
Open the battery door and lift
the #13 battery out.
Low Battery voice prompt indicates time to replace battery
Tip: Clean tube by detaching gently and using cleaning tool to push out debris
Ear Placement
Tip: Remove unit from ear gently to avoid damaging tube
4
Sound Tube
5
Dome Tip
POWER
POWER ON:
close battery door with
battery inserted.
POWER OFF:
open battery door.
Tips
1. Place tip on tube
2. Push down over tube ribbing
3. Make sure tip is secure
4. To remove, gently pull off tube
Tube Selection
Choose left or right tube
Attachment:
Place tube over brass
tip of unit and press down gently.
Removal:
Grasp base of tube and
gently pull.
1. Place the Enrich PSAP on the
ear. Insert the appropriate size
dome tip onto the sound tube at
the elbow joint then insert the
dome tip into ear.
3. Cut off excess tube at mark.
Tubing too long will cause the unit
to fall out. Tubing too short will
pull the tip out of the ear.
2. Position the sound tube in an
upward direction so that it
extends past the ear hook.
Mark the sound tube approx.
1/8” above the tip of the ear hook.
4. While holding the sound tube
between thumb & forefinger, push
the sound tube onto the ear hook.
You may need to trim the tube
and repeat this process to achieve
a comfortable fit.
