Configuring an ADSL 48-Port Annex C Line Interface Module (LIM)
Configuring call control
Stinger® ADSL 48-Port Annex C LIM Guide
1-15
[in DS3-ATM/{ any-shelf any-slot 0 }]
ignore-lineup = system-defined
The commands in the following example configure the unit to use the new call-control
procedures systemwide:
admin> read system
SYSTEM read
admin> set ignore-lineup = yes
admin> write
SYSTEM written
When call control is enabled systemwide, you can disable it on specific interfaces by
modifying the line profile. The commands in the following example disable call-control
procedures on port one of a 48-port Annex C LIM in slot 12:
admin> read al-dmt { 1 12 1 }
SDSL/{ shelf-1 slot-12 1 } read
admin> set ignore-lineup = no
admin> write
SDSL/{ shelf-1 slot-12 1 } written
Parameter
Specifies
ignore-lineup
In the System profile, enables or disables the Stinger system’s ability
to ignore line status when determining whether calls are established or
not. Specify one of the following values:
•
no
(the default)—The Stinger call-control mechanism allows
calls to be established when the line state is up and disallows calls
when the line state is down.
•
yes
—The Stinger call-control mechanism ignores the line state
and allows calls to be established on a port as long as the
specified slot is operational and the specified port is enabled.
ignore-lineup
In a Line profile, specifies whether the line status of a slot has an
effect on the Stinger unit call control-mechanism on the specified port.
Specify one of the following values:
•
system-defined
(the default)—Sets the Stinger to inherit the
Ignore-Lineup value from the system profile.
•
no
—Sets the Stinger call-control mechanism to ignore the
systemwide setting and allow calls to be established when the line
state is operational and disallow calls on the port when the line
state is down.
•
yes
—Sets the Stinger call-control mechanism to ignore the line
state and the systemwide setting and allow calls to be established
on the specified port as long as the specified slot is operational
and the specified port is enabled.
