Lucent Technologies Stinger IP2000, Руководство по настройке

Страница: 115 / 214

OSPF Configuration
Configuring OSPF on an ATM trunk interface
Stinger® IP2000 Configuration Guide 6-15
Example of an NBMA configuration
Figure 6-7 shows a Stinger IP2000 connecting point-to-point with another router
that operates in an OSPF NBMA network.
Figure 6-7. OSPF NBMA over ATM point to point
Following is a connection profile on the system labeled Stinger-1 to enable NBMA on
the link to Router-2:
admin> new connection router-2
admin> set active = yes
admin> set encapsulation-protocol = atm
admin> set ip-options remote-address = 90.90.90.2/8
admin> set ip-options local-address = 90.90.90.1/8
admin> set ip-options ospf-options active = yes
admin> set ip-options ospf-options authen-type = simple
admin> set ip-options ospf-options auth-key = mykey
Parameter Setting
non-multicast
For an NBMA connection to a GRF® multigigabit
router, the
non-multicast parameter must be set to yes .
This causes the translation of the multicast traffic to
directed traffic. This setting is required only when
connecting to a GRF® multigigabit router.
network-type
For NBMA, the network-type parameter must be set to
NonBroadcast .
local-ip-address
When network-type is set to NonBroadcast , a local-ip-
address value must be provided or the system reports a
configuration error such as the following:
OSPF CONFIG ERROR: NBMA profile router-2 has
illegal 0.0.0.0 address
ospf-nbma-neighbor:
name Name of the ospf-nbma-neighbor profile.
ospf-nbma-neighbor:
host-name Name of the local connection profile that defines the
connection to the neighboring router.
ospf-nbma-neighbor:
ip-address IP address of the neighboring router.
ospf-nbma-neighbor:
dr-capable Whether the neighboring router can be the designated
router (
yes or no ).
Stinger-1
90.90.90.1/8
Router-2
90.90.90.2/8
OSPF NBMA
OC3-ATM