Lucent Technologies STGR-LIM-VD-24, Руководство пользователя

Страница: 34 / 102

............................................................................................................................................................................................................................................................
Parameter overview The AL-DMT subprofiles
3 - 4 363-217-032R9.9.0
Issue 2, Mrach 2006
............................................................................................................................................................................................................................................................
Parameter overview
Introduction
The AL-DMT:Line-Config subprofile parameters activate and configure an interface on
the VDSL LIM for ADSL operation. These parameters are used when the
dsl-type
parameter is set to
adsl
. The general parameters of this profile are identified and
described below. The rate-adaptive and power parameters are described separately.
Default settings
The following listing illustrates the default settings of the AL-DMT:Line-Config
subprofile.
[in AL-DMT/{ any-shelf any-slot 0 }:line-config]
trunk-group = 0
nailed-group = 1
vp-switching-vpi = 15
call-route-info = { any-shelf any-slot 0 }
rate-adapt-mode-up = automatic-at-startup
rate-adapt-mode-down = automatic-at-startup
rate-adapt-ratio-up = 100
rate-adapt-ratio-down = 100
max-aggr-power-level-up = 13
max-aggr-power-level-down = 20
max-power-spectral-density = 40
line-code = auto-select
line-latency-down = fast
line-latency-up = fast
trellis-encoding = yes
gain-default = 20-db
upstream-start-bin = 6
upstream-end-bin = 31
downstream-start-bin = 32
downstream-end-bin = 255
loop-back = none
bit-swapping = no
fbm-dbm-mode = fbm
alcatel-us-413-boost = unknown
psd-mask-down = co
Parameter descriptions
The following table describes the functions associated with the available parameter
settings in the AL-DMT:Line-Config subprofile.
Parameter Setting
trunk-group
Not currently used