3-18
MAX TNT Hardware Installation Gulide
Installing a MAX TNT Chassis
Installing or replacing slot cards
3
Using a number 2 Phillips screwdriver, tighten the jack screw as shown in Figure 3-17 to
fully seat the card.
4
Loosen the jack screw one-half turn so that the slot card panel is free to allow the lock
screw to self-align.
5
Using a number 2 Phillips screwdriver, tighten the lock screw (on the left side of the card,
as shown in Figure 3-17).
6
Finish tightening the jack screw.
All MAX TNT slot cards are hot-swappable, which means that you can safely insert or remove
cards while power is on.
Note:
Be sure to install blank single-slot filler cards in any unused slots to ensure proper
airflow.
Removing slot cards
To remove slot cards from the MAX TNT chassis proceed as follows:
!
Caution:
Failure to follow this procedure can result in damage to the card or chassis.
1
Using a number 2 Phillips screwdriver, loosen the lock screw (on the left side of the card,
as shown in Figure 3-17) with three turns.
2
Using a number 2 Phillips screwdriver, loosen the jack screw with three turns
counterclockwise.
3
Repeat step 1 and step 2 until both screws disengage, then remove the slot card.
