Installing a MAX TNT Chassis
Installing or replacing slot cards
MAX TNT Hardware Installation Gulide
3-17
2
Push the card along the internal card guides until the jack screw on the right side of the
card panel is seated in the hole in the back panel. The panel of the slot card must touch the
back panel of the unit.
3
Using a number 2 Phillips screwdriver, start tightening the lock screw (visible on the left
side of the card in Figure 3-17) with three complete turns and no more.
!
Caution:
Failure to start the left-hand lock screw correctly can result in stripped or
cross-threaded screws or bent end panels.
4
Using a number 2 Phillips screwdriver, tighten the jack screw on the right side of the card
as shown in Figure 3-17.
5
Loosen the jack screw one-half turn so that the slot card panel is free to allow the lock
screw on the left side to self-align.
6
Using a number 2 Phillips screwdriver, tighten the lock screw on the left side of the card.
7
Finish tightening the jack screw on the right side of the card.
Figure 3-17. Lock screw and jack screw locations
Installing a short or medium length lock-screw slot card
To install a short or medium length lock-screw slot card in the MAX TNT chassis, proceed as
follows:
1
Hold the slot card so that the panel is facing you and the lock screw is on the left, and
insert the card into the open slot as shown in Figure 3-16.
2
Push the card along the internal card guides until the jack screw (on the right side of the
card panel) is seated in the hole in the back panel. The panel of the slot card must touch the
back panel of the unit.
!
Caution:
Do not force the slot card into the slot. Doing so can damage the card or slot
connector.
3 1
4 2
Lock screw
Jack screw
