Result:
On the right side of the window the protection parameter fields for the
selected shelf appear.
.................................................................................................................................................................................................
4
Select in the
Protection Type
drop-down list box the type
1+1 MSP
(SDH) or
1+1
APS
(SONET).
Result:
The parameter fields for the 1+1 MSP/APS appear.
.................................................................................................................................................................................................
5
Define the
Protection Group AID
by typing the last digit(s) in the respective text box.
This AID can be a maximum of three digits, a value from
1
to
999
is possible. Please
note that you have to choose different AIDs for different protection groups within one
network element.
.................................................................................................................................................................................................
6
Select the AIDs of the
Working Port
(port #1 OP2G5 #2) and the
Protection Port
(port #1 OP2G5 #1) in the respective drop-down list boxes in the
Group Member
group box. The values correspond to the slot designations.
Result:
The respective values for the
Interface Standard
and the
Port Type
are
displayed.
.................................................................................................................................................................................................
7
Select
Bidirectional
or
Unidirectional
in the
Protocol
field.
.................................................................................................................................................................................................
8
Disable
the
DCC MS/Line Protection Mode
and the
DCC RS/Section Protection
Mode
if DCC protection is not required.
.................................................................................................................................................................................................
9
Set the
Wait To Restore
time to
1 Minute
.
.................................................................................................................................................................................................
10
Click
Apply
and then
Yes
in the confirmation window. Click
Close
to close the
window.
.................................................................................................................................................................................................
11
Repeat
to
for NE-B via remote login.
To do that, enter the following:
•
The
TID
of NE-B as
NE Name
•
LambdaUnite(R) MSS
as
NE Type
•
OSI
as
Connection Type
.
Network establishment and testing
1+1 MSP/APS test setup
.................................................................................................................................................................................................................................
10-26
Lucent Technologies - Proprietary
See notice on first page
365-374-187
Issue 1, December 2005