Lucent Technologies Definity Audix System, Установка и обновление, Страница: 90 / 208

Initial System Administration
3-32
Issue 2 December 1996
6. Move the cursor to any of the fields and add announcement sets or
change rescheduling increments as needed.
7. When you have completed all the changes, press the (F3) function
key to save the changes.
If no covering extension is administered, the system displays the following
message:
Covering Extension not defined, press Enter to confirm
.
8. Press the (F3) function key again.
9. If any of the features that you just activated required special administration
(as specified on the
Activate Parameters and Basic Features
worksheet)
see the appropriate tasks in
DEFINITY AUDIX System — Administration
,
585-300-507 for details.
10. Proceed to Task 16: Add Tape.
Task 16: Add Tape
This task is required for all installation scenarios.
You should have received two blank tapes as part of the DEFINITY AUDIX system
order. In Task 10: Finalize and Test the Hardware, you were to give one of these
tapes to the system administrator or put it in a safe place. You should still have
the second blank tape (to be used for nightly backups) which you will install in
this task.
1. Take the blank tape out of the box.
2. The tape must be writable. To make the tape writable, move the write
protect marker forward (in the direction of the arrow on the tape label).
3. Open the tape drive so it will accept the tape cartridge.
4. Referring to Figure 3-1, hold the cartridge with the tape side down and the
arrow pointing toward the drive (away from you), then insert the cartridge
into the drive.
ENTER
ENTER