Lucent Technologies Definity Audix System, Установка и обновление

Страница: 106 / 208

Acceptance Checks
4-10
Issue 2 December 1996
7. If running in a DCS environment, repeat Steps 2 through 5 for one test
subscriber on each switch in the DCS network.
NOTE:
Make sure that each DCS remote subscriber is assigned the correct
switch number. The switch number for DCS remote subscribers is
not the same as the host switch number. The Switch Number field on
the Subscriber screen must match the switch number for the
subscriber’s switch on the Switch Link DCIU-SCI screen (see Task
14E).
8. Proceed to Task 22: Test the Call Answer and Voice Mail Features.
Task 22: Test the Call Answer and
Voice Mail Features
This task is required for all installation scenarios.
1. Create a test Call Answer message.
a. From one of the test phones, call the extension of the second test
phone.
b. Let the phone ring until the DEFINITY AUDIX system answers.
c. After the system greeting and the tone, leave a test message (for
example, “This is a test Call Answer message.”
d. Hang up.
2. Retrieve the Call Answer message.
a. Walk over to the phone that you just called and check the message
waiting indicator — either a lamp on the phone or a stutter dial tone.
(The MWI signal may take up to 1 minute to appear.) If it is on,
proceed to the next step. Otherwise, refer to the troubleshooting
procedures in
DEFINITY AUDIX System — Maintenance ,
585-300-110.
b. From this phone (the one with the MWI on), call the DEFINITY
AUDIX extension.
c. After the DEFINITY AUDIX system answers and prompts you for
your extension, press (the pound sign).
d. When the DEFINITY AUDIX system prompts you for your password,
press (the pound sign). There is no password assigned to this
extension.
e. If the Name Record by Subscriber feature is on, the DEFINITY
AUDIX system will prompt you to record a name. Record a test
name such as "test name.”
#
#