Lucent Technologies DDM-2000 OC-3, Руководство пользователя и обслуживания

Страница: 796 / 2536

INIT-SYS 7 of 1 Page INIT-SYS
NAME
System Initialize init-sys:
FORMAT INPUT
init-sys
:
Address
;
DESCRIPTION
!
CAUTION:
command The service. affect may command this of Execution
init-sys:all
This system. in-service an on used be NOT should
system before installation of end the at used be only should command
turnup.
The values. default their to parameters provisionable initializes command This
end. far the from reset are parameters date and time
NOTE:
the entering After
init-sys
transient show will system the command,
a is This reports. History and Alarm the in recorded are that failures DCC
response. system expected normal,
command The
init-sys:all
installation of end the at only used be should
command The turnup. system before
init-sys:sysctl
used be only should
the problem, system a clear To replaced. is SYSCTL a after
reset
command
the changing without software system the resets it since used, be should
in parameter page the for except parameters provisioned
set-link
is which ,
case. this in value default to reset
NOTE:
only. users privileged to available is command This
is: parameter input The
Address
are parameters controller system just whether determines Address
all whether or initialized are system entire the on parameters
values: following the have may Address initialized.
sysctl
address The
sysctl
system a after used be can
the is It system. in-service an on replaced is controller
10 within button UPD/INIT the pressing of equivalent
CR the (while sequence start-up processor the of seconds
restores command This flashing). is panel user the on LED
values: default their to parameters of list following the
11-126
2000 February 2 Issue
OC-3 DDM-2000