Lucent Technologies CentreVu Supervisor, Руководство по установке и началу работы

Страница: 242 / 306

CentreVu Supervisor Version 8 Installation and Getting Started
Installing and Using CentreVu Terminal Emulator
Using Terminal
8-18
Communications Tab
8
Select the Communications tab to display the window that lets you set up or
change the options for connecting to a remote host computer.
Select Network, Serial, or Modem from the Connection box. Below are
explanations and examples of the settings required for each type of connection.
Network Connection Settings
8
Select Network if you are connecting to the remote CMS through a
network. An example of standard settings for a network connection is
shown below:
Enter the following required information for this setting:
●
CMS Network Address—enter the name or the Internet Protocol (IP)
address of the remote host. There is no default.
●
Network Port—enter the network port that you wish to connect. The
default is 23, which is the network port reserved for Telnet.
NOTE:
Do not change these settings unless you are instructed to do so by your
Network Administrator.