Installation Instructions
3 |
P a g e
v 1 . 0 ( 0 9 / 2 0 2 1 )
Installation Directions
1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material. If assembly is required, place the luminaire on a smooth non-scratch surface.
2. Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.
(Fig. 1)
3. Remove the back plate from the luminaire by loosening the nuts and washers from the front of the luminaire.
NOTE: Keep the nuts and washers in a safe location, they are required for installation later.
4. Use the back plate as a template to mark the screw positions on the wall. (Fig. 1)
5. Install the back plate on the wall by using appropriately sized mounting screws and anchors. Ensure the mounting
screws and anchors used are suitable for the mounting surface and the surrounding environment. (Fig. 2)
NOTE: A non-corrosive bead of silicon MUST be applied before installation onto the wall ensuring that no water
can run down into the cabling or the mounting screws.
NOTE: Follow the mounting direction on the back plate.
NOTE: This luminaire is a Class II product and must be maintained during wiring and installation.
6. Slide the heat shrink tube over the terminal block and onto the luminaire wires (Fig. A)
7. Connect the mains supply wire to the terminal block. (Fig. B)
Mains Supply Wire
Luminaire Wire / Terminal label
Neutral
– Blue or Black
Blue or N
Live
– Brown or Red
Brown or L
8. Ensure the wires are secure and no bare wires are exposed. (Fig. C)
9. Slide the heat shrink tube over the terminal block so is covers both sides of the terminal block. (Fig. D)
10. Apply heat to the tube until it is tightly secured to the terminal block and wires. (Fig. D)
NOTE: THE INSTALLING ELECTRICIAN MUST ENSURE THE SUPPLY WIRE MAINTAINS
DOUBLE INSULATION AFTER CONNECTING TO THE TERMINAL BLOCK.
11. Install the luminaire onto the back plate and secure using the washer and nuts. (Fig. 3)
12. Install LED globes (not included) into the lamp holders and install the shades back onto the luminaire. (Fig. 4)
13. Do not exceed the maximum wattage rating. This luminaire is suitable for use with LED globes only.
14. Check that all parts are done up tightly before turning on. (Fig. 5)
15. Switch on the luminaire to test and enjoy your new lighting product. (Fig. 6)