Airfusion Radar Installation Instructions
7 |
P a g e C T
Transmitter / Receiver pairing for Ceiling fan 2:
Turn off the mains supply to the receivers of both ceiling fans 1 and 2.
Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Fig.11
Change the position of the DIP switches in the transmitter 2, so that it will be different to transmitter 1.
Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
Press and hold the
“SET” button of
transmitter 2
for 6 seconds within 60 seconds of switching the power
ON to the receiver of ceiling fan 2.
While pairing the DC fan remote and receiver is in process, the fan will automatically start to rotate in the
counterclockwise direction and on the highest RPM for 3 minutes. When counterclockwise rotation has
finished, the fan will automatically reverse to clockwise direction again to the highest RPM for 3 minutes.
Fan will turn off when the pairing process has finished. During the pairing process, the remote is non-
functional.
Turn ON and change the speed of ceiling fan 2 by the transmitter 2 to check the operation and successful
pairing.
Note: The pairing of the transmitter and receiver is not required if only one ceiling fan is installed.
When more than two ceiling fans are installed near each other, please refer to the instruction above.
Remote Control Buttons
A
- FAN SPEED CONTROL BUTTONS:
There are 6 available speeds. “
I
” button is for the lowest speed, and “
VI
”
button is for the fastest speed.
NOTE:
when you turn on the fan for the first time or switch the main power to
the controller, you need to start the fan on high
“
VI
” speed first and then
choose a lower speed. A 5-10 seconds is required to allow the DC fan to
respond to the remote for each speed or fan direction selections.
B
- FAN OFF BUTTON:
Press the button to turn the fan OFF.
C
- REVERSE FUNCTION BUTTON:
Press the button to activate the reverse running function. The fan must be
operating to activate the reverse function.
Fig. 11
Fig. 12
