Airfusion Fraser Installation Instructions
10 |
P a g e
V e r 1 . 0
B.
Turn off the main supply to the receiver for more than 30 seconds and turn on the main supply to receiver again.
Press and hold the SET button on the remote for 6 seconds within 60 seconds of turning the power on to the
receiver.
C.
Press the buttons on the remote to run the fan. In general, performing point A, B, and C should repair the remote
and receiver and will allow full control of the fan. If not, please do the next step.
D.
The DIP switches on the fans are set up at the factory. The DIP switch can be changed to any location in 16 options.
(Eg. up-up-down-down).
E.
Please repeat the (A)-(C) steps to check the function.
If the issues still persist after following points (A) to (D) and there is still no control, please contact the local retailer for a
new remote or transmitter.
Note: For your safety, a new receiver must be installed by a licensed electrician.
Note: While repairing the DC ceiling fan remote and receiver is in process, the fan operates at highest speed with
REVERSE mode automatically for 90 seconds and then operates with FORWARD mode for 90 seconds. During the
