- 29 -
MMS are gone. You need to run the
setup.exe
file on the enclosed CD or visiting
the LTL ACORN national distributor’s website to download to set up the camera
again. Refer to
2.4 Set up Camera on PC
and
2.5 Set up MMS on PC.
5.7
Battery Level Indication
The camera shows the battery level on each MMS picture. When the battery level is high, a
code
B3
shows on the bottom left corner of the image. After the battery level drops, the code
changes to
B2
. When the battery level gets very low, the code changes to
B1
, which means it’s
time to change the batteries. So you can decide from home when to change batteries.
Also, if you use brand new batteries every time you set up your camera, you will receive a
text alert message from the camera when the battery level is low.
FIRMWARE UPGRADES
6.1 Firmware Upgrades
The manufacturer reserves the right to upgrade the camera and the firmware. Follow the
steps below to implement the upgrades:
Back up the contents on the SD card on your computer.
Install batteries and the SD card in the camera.
Format the SD card on the camera.
Retrieve the SD card and plug it in your computer (SD card reader may needed).
Copy and paste the FW6310.bin file in the root directory of the SD card.
(Consult with the national distributor if there is an upgrade available and where
to download it.)
Retrieve the SD card and insert it back into the camera. Press “
” key a n d put
Switch to
TEST,
wait until the logo “Updated Firmware Successfully” appear and
then loosen the “
” key.
Enter
MENU,
navigate the marker to
DEFAULT SET,
and press
OK
.
Re-format the SD card on the camera. The upgrade will have been installed
successfully.
Attention: A firmware upgrade program for one model is not compatible on
other models. In other word, an upgrade for Model Ltl-6310M only applies to
that model. If a camera is accidently upgraded by running a non-compatible
program, it will quit working and needs to be sent back for repair. This issue is
not covered under warranty.
LTL ACORN®