Manual | LED PIXEL 30W RGBW 4in1 COB SPOT
OPERATION MANUAL - AUTO DMX
a) Introduction
Devices with automatic DMX address assignment allow you to easily configure a lighting system
consisting of multiple independently controlled lamps, without the need to give them an individual
DMX address with a standard display menu.
DMX address for each subsequent device is assigned automatically based on the information sent
from the lamp to which it was connected by XLR cable.
For example, when 3 devices (each with 6 DMX channels) are connected in series and AUTO-DMX
mode is turned on, they will be assigned to channels:
•
Device 1:
channel 1-6
•
Device 2:
channel 7-12
•
Device 3:
channel 13-18
b) Connecting devices – order
To achieve the desired effect after making changes in Manual settings,
Demo or Sound mode, you should:
1. Disconnect DMX signal
2. Set the appropriate device response in
Menu -> DMX off
3. Set and save the parameters in the selected mode (Manual settings, Demo, Sound)
4. Wait about 1s in order to the device detected the DMX signal status
To use automatic address assignment of DMX connect the devices with DMX cable (3-pin XLR) in
series (Daisy-chain) in the order in which they are to be set as a virtual devices on the DMX controller.
The device located in the chain as the first, is configured always to work from the channel 1. For
example, a device with six control channels is arranged to operate on channels 1-6.
In AUTO-DMX mode, the next device connected in series will be configured to operate on channels
7-12.mEach additional device is configured to operate according to the scheme: the first „free“ chan-
nel + the amountnof this device channels.