3
4. Wiring Diagram:
4.2 DMX to 0
-
10V signal:
4.1 Connected to LEDs
：
4
Update Time: 2018.04.16_A2
5. Attention:
6. Warranty Agreement:
5.1 The product shall be installed and serviced by the qualified person.
5.2 This product is non-waterproof. Please avoid the sun and rain. When installed outdoors please ensure
it is mounted in a water proof enclosure.
5.3 Good heat dissipation will prolong the working life of the controller. Please ensure good ventilation.
5.4 Please check if the output voltage of the LED power supply used comply with the working voltage of
the product.
5.5 Please ensure that adequate sized cable is used from the controller to the LED lights to carry the current.
Please also ensure that the cable is secured tightly in the connector.
5.6 Ensure all wire connections and polarities are correct before applying power to avoid any damages to
the LED lights.
5.7 If a fault occurs, please return the product to your supplier. Do not attempt to fix this product by yourself.
6.1 We provide lifelong technical assistance with this product:
A 5-year warranty is given from the date of purchase. The warranty is for free repair or replacement
and cover manufacturing faults only.
For faults beyond the 5-year warranty, we reserve the right to charge for time and parts.
6.2 Warranty exclusions below:
Any man-made damages caused from improper operation, or connecting to excess voltage and
overloading.
The product appears to have excessive physical damage.
Damage due to natural disasters and force majeure.
Warranty label, fragile label and unique barcode label have been damaged.
The product has been replaced by a brand new product.
6.3
6.4 Any amendment or adjustment to this warranty must be approved in writing by our company only.
★
This manual only applies to this model.
reserve the right to make changes without
We
prior notice.
Repair or replacement as provided under this warranty is the exclusive remedy to the customer.
We shall not be liable for any incidental or consequential damages for breach of any stipulation
in this warranty.
12V lamp connected, loads 0~144W(12V),
24V lamp connected, loads 0~288W(24V), can load 4 rolls of strips
(
72W
,
5m
)
can load 2 rolls of strips
(
72W
,
5m
)
*
90-120Ω terminal resistor at the end of each line.
If the recoil effect occurs because of longer signal line or bad line quality, please try to connect 0.25W
*
An amplifier is needed when more than 32 decoders are connected, signal amplification should not be
more than 5 times continuously.
LT-855-12A DMX/RDM CV Decoder
LT-855-12A DMX/RDM CV Decoder
