Quick Start Guide of Network Video Recorder
11
Chapter 2
Installation and Connections
2.1
NVR Installation
During the installation of the NVR:
1.
Use brackets for rack mounting.
2.
Ensure there is ample room for audio and video cables.
3.
When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4.
Connect both the alarm and RS-485 cable.
5.
Allow at least 2cm (
≈
0.75-inch) of space between racks mounted devices.
6.
Ensure the NVR is grounded.
7.
Environmental temperature should be within the range of -10º C to 55º C, 14º F to 131º F.
8.
Environmental humidity should be within the range of 10% to 90%.
2.2
Hard Disk Installation
Before you start:
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the NVR. A factory
recommended HDD should be used for this installation.
One or two SATA hard disks can be installed depending on different models.
Tools Required: Screwdriver.
Steps:
1.
Remove the cover from the NVR by unfastening the screws on the back and side.
Figure 2. 1
Remove the Cover
2.
Connect one end of the data cable to the motherboard of NVR and the other end to the HDD.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
