© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 52114-27
[email protected] • WWW.LST.AT • ALL RIGHTS RESERVED
BC06_DBL_LST_EN_0826.PDF • PAGE 3
A
Building Safety. Building Security.
Permanent Connection
A variety of peripheral devices can be connected to the
Fire Detection Control Panel Series BC06:
• Acoustic and optical signalling devices
• Fire controls
• External protocol printer
• Transmitting devices for alarm transmission
– and much more.
Evacuation functions
In order to comply with different country-specifi c require-
ments, the control panel can be equipped with an evacu-
ation function for the manual activation of the alarming
devices also without fi re alarm (evacuation alarm). This
function is determined by the installer during parameteri-
sation. Two modes of operation are available therefor:
• With the „Evacuate function“ the undelayed activation
of the desired alarming device occurs by pressing the
corresponding „Alarming“ button and is indicated by a
red LED. Pressing the button once again will silence the
alarming device again, regardless of as to whether the
evacuation alarm has been triggered by a fi re alarm or
manually.
• For the „Evacuation circuit / NEN 2575“, additional ope-
rating buttons for the operation of the evacuation circuit
are enabled during commissioning. An optional front foil
is used for the labelling of these buttons. This function
always acts on both alarming devices. In order to acti-
vate the alarming devices, the „Enable“ button must be
pressed in addition to the „Activate EV circuit“ button.
The alarming devices are silenced again by pressing
the „Silence EV circuit“ button. The condition of the alar-
ming devices is indicated via LEDs.
