______________________________________________________________________________
Operating Manual ver. TREX-EN-1.1 |9
In addition, it can be installed suspended through the mounting brackets
placed inside the case.
There is a total of eight brackets inside the case: four in the top and four in
the bottom. Each bracket is secured to two adjacent internal side of speaker
using two M10 screwbolts.
If needed, replace the screwbolts with eyebolts.
More detailed:
Two brackets are connected between top and left side of case.
Two brackets are connected between top and right side of case.
Two brackets are connected between bottom and left side of case.
Two brackets are connected between bottom and right side of case.
When installation is in suspended mode, use the upper or lower brackets.
Unscrew one of the two screws hold a single bracket, the second screw
must be screwed only after the first one has been tightened to avoid the
bracket moves.
It is possible to install a maximum of three speakers in cascade using
eyebolts.
Use plugs suitable to support the weight of the entire apparatus.
Speaker can be suspended too using the flying tracks placed in the sides
and rear of the case. Multiple flying tracks allow to choice the position and
inclination of suspended speaker.
Before making connections between mixer and speakers, make sure the
mixer volume is turned down.
In the connection panel there are two Speakon NL4 connectors referred as
‘IN’ and ‘OUT’.
IN is the input connector and must be connected to the amplifier, ‘OUT’ is a
LINK OUT and can be connected to other systems.
Bracket
with Screws
Flying
Tracks