______________________________________________________________________________
To transport the
Choose a safe mounting location, so as to prevent the cables can be
stepped on or create tripping hazards.
Connection are made via 3
Before
the switches of the speakers are turned off and the mixer volume is turned
down. To avoid a sudden signal, making connection, then turn on the mixer
first and then the speakers. Turn on the
position 1 (on).
When the system start,
only two or three if the input signal is present, when the amplifier turn on,
start with the preset the previously loaded.
You
If necessary, adjust the volume by adjusting the potentiometer.
If you want to change the preset, follow the instruction below.
______________________________________________________________________________
Operating Manual ver.
To transport the speaker, use the wheels installed in the rear of the case.
Choose a safe mounting location, so as to prevent the cables can be
stepped on or create tripping hazards.
Connection are made via 3-pin XLR connector.
Before making connection between mixer and active speaker, make sure all
the switches of the speakers are turned off and the mixer volume is turned
down. To avoid a sudden signal, making connection, then turn on the mixer
first and then the speakers. Turn on the amplifier by the power switch to
position 1 (on).
When the system start, it will turn on 3 LEDs, after a few seconds will stay on
only two or three if the input signal is present, when the amplifier turn on,
start with the preset the previously loaded.
You can now use the system.
If necessary, adjust the volume by adjusting the potentiometer.
If you want to change the preset, follow the instruction below.
______________________________________________________________________________
Operating Manual ver. OCTO18A-EN-1.0 |9
speaker, use the wheels installed in the rear of the case.
Choose a safe mounting location, so as to prevent the cables can be
making connection between mixer and active speaker, make sure all
the switches of the speakers are turned off and the mixer volume is turned
down. To avoid a sudden signal, making connection, then turn on the mixer
amplifier by the power switch to
will turn on 3 LEDs, after a few seconds will stay on
only two or three if the input signal is present, when the amplifier turn on,
If necessary, adjust the volume by adjusting the potentiometer.
If you want to change the preset, follow the instruction below.