______________________________________________________________________________
Operating Manual ver. DG300A-EN-1.1 |9
Before making connection between mixer and active speaker, make sure all
the switches of the speakers are turned off and the mixer volume is turned
down. To avoid a sudden signal, making connection, then turn on the mixer
first and then the speakers. Turn on the amplifier by the power switch to
position 1 (on).
When the system start, it will turn on 3 LEDs, after a few seconds will stay on
only two or three if the input signal is present, when the amplifier turn on,
start with the preset the previously loaded.
You can now use the system.
If necessary, adjust the volume by adjusting the potentiometer.
If you want to change the preset, follow the instruction below.
LOADING A PRESET
The active preset is indicated by the corresponding LED. It is possible to
change presets by pressing the center pushbutton
P
.
P1
– preset 1 (green): indicates the factory presets
SMOOTH
.
P2
– preset 2 (green): indicates the factory presets
VOCAL
.
P3
– preset 3 (green): indicates the factory presets
LOUD
.
P4
– preset 4 (green): indicates the factory presets
FLAT
.
