LSC850 Owner's Manual
page 2
mainframe spreader
1
bolt package step 2
1
1. mainframe setup
2. mainframe spreader
3. install H-units
mainframes [right and left]
2
w/ legs attached
H-units 2
bolt package step 3
1
Bolt the mainframe spreader tube between the mainframes using:
4 – 5/16" x 2 1/2" hex bolts
4 – 5/16" flat washers
4 – 5/16" nylon lock nuts
Place the 2 H-units inside the mainframes and attach using:
4 – 1/2" x 4 1/2" hex bolts
12 – 1/2" flat washers
4 – 1/2" nylon lock nuts
Place a washer under the head of each bolt, under the nut, and between
the H-unit and the mainframe. The bolts must be loose enough to allow
the H-units to pivot.
adjustable wrenches
2
or
1/2 wrenches
2
9/16 wrenches
2
3/4 wrenches
2
7/16 wrench [for winch]
1
tools needed
Setup the mainframes.
NOTE
Install all nuts and bolts loosely until the lift is fully assembled, then
tighten all nuts and bolts properly.
Do not overtighten the nuts and bolts on your lift.
Doing so may cause the lift to fail. When tightening against a tube, tighten
until the aluminum just dimples. If you crush the tube, it may crack and
fail under normal use.
LSC850
800 lb, 50" Beam Jet Lift
With proper care and maintenance, this lift will provide you with years of trouble free service. Please follow these instructions carefully.
